What is Orbicraft for?
Assembling the OrbiCraft 3D
OrbiCraft 3D interfaces
Work with earth-based VHF
Work with Wifi
Work through the WEB interface
Houston Control Center Software
Arduino-Based payload
Laboratory equipment
Feedback
What is Orbicraft for?
Assembling the OrbiCraft 3D
OrbiCraft 3D interfaces
Work with earth-based VHF
Work with Wifi
Work through the WEB interface
Houston Control Center Software
Arduino-Based payload
Laboratory equipment
Feedback
1) Install two side walls on the lower base (marked: tester ↓). To do this, position the projections of the side walls with holes in the base and snap.
2) Install the tester board.
3) Attach the board to the bottom base using four PCHSS brass M3x8 posts and four M3x10 countersunk screws.
4) Fix two windows on the bottom base. To do this, guide each window along the guides in the walls to the base and snap into place.
5) Assemble the upper base (marked: tester ↑) with the window using M3x8 pan-head screws.
6) Install the top cover on the assembled body. To do this, position the cutouts on the top cover and the protrusions of the two walls and two windows and snap into place using force.
7) Attach the top cover with four M3x10 countersunk screws. This is how the assembled ribbon cable tester module looks like: