What is Orbicraft for?
Assembling the OrbiCraft 3D
OrbiCraft 3D interfaces
Work with earth-based VHF
Work with Wifi
Work through the WEB interface
Houston Control Center Software
Arduino-Based payload
Laboratory equipment
Feedback
What is Orbicraft for?
Assembling the OrbiCraft 3D
OrbiCraft 3D interfaces
Work with earth-based VHF
Work with Wifi
Work through the WEB interface
Houston Control Center Software
Arduino-Based payload
Laboratory equipment
Feedback
1) Install the UHF board on the lower base (marked: UHF ↓). Fix the board with four PCHSS brass struts M3x15 and four countersunk screws M3x10
2) Install the side panels on the bottom base. To do this, position the side wall projections with holes in the base and snap into place.
3) Install two windows on the bottom base. To do this, guide each window along the guides in the walls to the base and snap into place.
4) Install the top cover (marked: UHF ↓) on the assembled body. To do this, position the cutouts on the top cover and the protrusions of the two walls and two windows and snap into place using force.
5) Fasten the cover with four M3x10 countersunk screws
6) Connect the antenna to the UHF board. The assembled UHF ground module looks like this: